Skip Navigation

Steel Wall Ties

Ancon are one of the UK’s leading designers and manufactures of Steel Wall Ties. Below is an introduction to a number of products from the Staifix range.

HRT4

  • The Staifix HRT4 is available in 4 lengths suitable for cavities from 50mm to 150mm and used in the external walls of houses up to 10 metres in height. Altitude and wind speed restrictions may apply.
  • Type A tie suitable for internal separating walls of buildings of any height
  • CE Marked, Declaration of Performance available and meets the technical requirements of the NHBC
  • Safety ends to reduce the risk of injury during handling and installation
  • Manufactured from corrosion-resistant stainless steel
  • Multidrip prevents water crossing the cavity
  • Available in bags of 20 and boxes of 250

 

Cavity Width (mm)                 Staifix HRT4 Tie Length (mm)
50-75 200
76-100 225
101-125 250
126-150 275

 

RT2

RT2

  • The Staifix RT2 is available in 4 lengths suitable for cavities from 50mm to 150mm and is used in the construction of domestic houses and small commercial buildings up to 15 metres in height.
  • The Staifix RT2 is CE Marked and meets the technical requirements of the NHBC.
  • Safety ends to reduce the risk of injury during handling and installation
  • Manufactured from corrosion resistant stainless steel.
  • Multidrip prevents water crossing the cavity
  • Available in bags of 20 and boxes of 250

 

 


 

Cavity Width (mm)              Staifix RT2 Tie Length (mm)
50-75 200
76-100 225
101-125 250
126-150 275

 

Universal Insulation Retaining Clip

Universal Insulation Retaining Clip

  • For use with most standard Ancon and Staifix wall ties in partial fill cavities
  • Available in bags of 20 and 250
     

 

 

 

 

 

Starter Tie

  • Screw-in starter tie for joining new masonry to existing walls without the need for jointing
  • Supplied with Wall Plugs
  • CE Marked, Declaration of Performance available
  • Safety ends to reduce the risk of injury during handling and installation
  • Manufactured from corrosion-resistant stainless steel 
  • Meets the technical requirements of the NHBC   
  • Available in bags of 10, boxes of 100 or individually in store from box of 100

 

 

Frame Tie

Frame Tie

  • A screw-in tie used to join timber door and window frames to brickwork.
  • No pilot hole required
  • It is suitable for use in buildings up to 15 metres in height
  • CE Marked with Declaration of Performance available
  • Meets the technical requirements of the NHBC   
  • Available in bags of 10, boxes of 100 or individually in store from box of 100